9
By pushing the increment button (with
speed being displayed) for more than two
seconds, the display will change between
standard mph or metric kph.
With RPM displayed on the readout
screen by pushing and holding the incre-
ment button, maximum RPM will be dis-
played on the readout screen. The
maximum RPM readout will reset when
the decrement button is pushed (while
maximum RPM is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the trip
meter displayed, push and hold the decre-
ment button until the display is cleared.
The hour-meter readout will not reset.
Clock/Altimeter
By pushing the select button, the readout
screen will display clock, altimeter, and
maximum altimeter.
To set the clock, select clock on the display
by pushing and holding the select button
for two seconds; the option of selecting the
12-hour or 24-hour clock mode is avail-
able. Push the increment button to toggle
between the 12-hour display and the 24-
hour display. When desired mode is dis-
played, push the select button.
At this point, the hours display will begin
to flash. Push the increment button to
increase the hours; push the decrement
button to decrease the hours. Pushing and
holding a button will accelerate the num-
ber display. When desired hour number is
displayed, push the select button.
At this point, the minutes display will
begin to flash. Push the increment button
to increase the minutes; push the decre-
ment button to decrease the minutes.
Pushing and holding a button will accel-
erate the number display. When desired
minute number is displayed, push the
select button.
NOTE: During clock setting if no
button (increment, decrement,
select) is pushed within a 5-second
time period, the clock-setting mode
will be exited with changes saved.
NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
To set/calibrate the altimeter to an estab-
lished altitude with altimeter selected on
the display screen by pushing and hold-
ing the select button for a minimum of
two seconds, the acronym CAL will be
displayed on the readout screen for one
second; then the altitude value will flash.
Push the increment button to increase the
displayed altitude; push the decrement
button to decrease the displayed altitude.
Pushing and holding a button will accel-
erate the number display.
NOTE: If MPH has been selected in
the speed readout, the altitude value
will be displayed in feet. If kph has
been selected in the speed readout,
the altitude value will be displayed in
meters.
To reset the maximum altimeter readout
with the maximum altimeter displayed,
push and hold the select button for a min-
imum of two seconds.
Service Icon
On electric start models, the icon should
briefly illuminate each time the key is
turned to RUN or START, and engine is
started; then it should go out when the
engine starts. If the icon stays illuminated
(on electric start models) or it illuminates
while the engine is running, the system is
receiving input that is outside of its estab-
lished parameters. If the icon illuminates
indicating an error, take the snowmobile
to an authorized Arctic Cat Snowmobile
dealer for service. If not under warranty,
this service is at the discretion and
expense of the snowmobile owner.
Coolant Temperature
Warning Icon
When the engine reaches proper operat-
ing temperature, the coolant temperature
warning icon and TEMP display will
cease to flash.
