Arctic Cat 2010 1000 H2 TRV, Operator'S Manual

Page: 59 / 104

57
GENERA
L INFOR
M
A
T
ION
A. Volt - The LCD will go blank
except the word VOLT will
flash on the LCD whenever a
low voltage (< 9 DC volts) or a
high voltage (> 16 DC volts) is
detected. When voltage returns
to normal, the gauge must be
reset by turning the ignition
key to the OFF position and
then to the ON position.
B. EFI - The LCD will go blank
except the letters EFI will flash
on the LCD whenever an elec-
tronic fuel injection error is
detected. After 30 seconds, the
LCD will return to normal;
however, the letters EFI will
continue to flash.

NOTE: Take the ATV to an autho-
rized Arctic Cat ATV dealer to have
the EFI error corrected and to have
the gauge reset as soon as possible.
SPEEDOMETER/LCD
(Analog/Digital)
CF094A
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12 hour mode; the hour meter indi-
cates the total time the ATV has
run and cannot be reset to zero. To
set the clock, use the following
procedure.
A. With the ignition switch ON,
press and release the Mode
Button (3) until the Clock/
Engine Hour Meter (1) is dis-
played; then (if necessary)
press and release the Set/Reset
Button (4) to the clock display.
B. Press and hold the Set/Reset
Button (4) until the minutes
stop scrolling and the hour dis-
play starts to scroll. Momen-
tarily release when the correct
hour is displayed; then repeat-
edly press and release the Set/
Reset Button (4) until the cor-
rect minutes are displayed.

NOTE: Approximately two sec-
onds after releasing either Button,
the LCD will return to normal oper-
ation.

NOTE: Clock memory power is
supplied through the 15-amp
accessory fuse and verified during
gauge “power-up” and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will “power-up,” reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.

NOTE: The engine hour meter
will not activate until engine speed
exceeds 500 RPM.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom seg-
ment flashes, approximately 3.5 L
(0.92 U.S. gal.) of gasoline remains
in the tank.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer, distance, and
time.

NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two sec-
onds after the Mode Button is
released, the digital gauge will
return to full display.