The LI-2B gate operators are suitable for gates that are correctly hinged and operate
smoothly and evenly both before and after the LI-2B gate operator is fitted.
The LI-2B gate operators are suitable for and guaranteed when the following conditions are
met.
The LI-2B gate drive system will drive a variety of gate styles, sizes and weights. Suitability
is dependant on the quality of hinging and the ongoing force required at ONE metre from the
hinge centre-point to open and close the gate. 15kg is the acceptable maximum for gates
opening IN (Pull) and 7.5kg for gates opening OUT (Push)
Do not connect to any 240-volt power, solar panel or battery if you do not understand any of
the instructions or have any doubts. Please call, fax or email us re your concerns BEFORE
you apply power to the unit or you may void your warranty.
DO NOT connect the RED spade terminal to the battery until you are ready to set the Limit
Switches. The RED spade terminal is supplied disabled* from the battery. (* i.e. Not
connected to the battery)
Important
•
All power (240 volt/battery/solar panel) MUST be disconnected before moving Logic
Controller (circuit board) to change battery.
•
Correct use of a SURFACE insecticide spray** is advised to deter insects from causing
damage to the electronics.
** To avoid loss of warranty – DO NOT SPRAY OR ALLOW ANY LIQUIDS ONTO ANY
ELECTRONIC CIRCUITRY.
LI-2B Installation Manual
