28
Installation
15.0 Glass Door Installation
WARNING:
Do not operate appliance with the glass front cracked or broken. Replacement of the glass should be done by a licensed
or qualified service person. Do not attempt to remove the glass door when the appliance is hot. Be sure there are no
fingerprints left on the glass panels during install or when cleaning as high temperatures can bake these prints on
permanently. Inspect the door gasket to ensure no damage has occurred when installing the door.
15.1 If Your Glass Breaks
If the glass door should crack or break, replace the original door assembly with the manufacturer's door assembly
(part number: RP-822-0000).
•
Remove the barrier screen (see
Section 14.0
)
•
Remove the door as described above
•
Replace the door assembly
•
Reinstall the barrier screen
Note:
the NEW door will emit an odor when the appliance is lit. The odor will dissipate after the gasket material within the door has
cured.
Warning:
Only doors certified with the appliance shall be used. Do not use substitute glazing materials.
Step 1:
Align the door with the firebox opening. Slip the tabs on the top of the firebox through the openings in the top of the door.
Figure 15.0.01:
The door and barrier screen install together using the same screws. Be sure to place the Glass Door over the tabs on the top of the
firebox prior to installing the screen. Never operate this fireplace with the door removed.
Step 2:
Place the barrier screen over the tabs on the top of the firebox and install both the door and screen together using the two
screws included with the fireplace (see
Section 14
).
Removal is the reverse of installation.
(Electronic Ignition version shown)
Summary of Contents for 22-DVIE22LN-1
Page 64: ......
