MaxR-3210 Wireless-N Access Point User Manual
Arada Systems Confidential
13
v1.1, Dec 2009
6.
Click
Apply
to save your settings.
Configuring an MaxR-3210 as a Point-to-Multi-Point Wireless
Bridge
To configure a point-to-multi-point wireless bridge as shown in
1.
Under the
Configuration
tab, select
Wireless Bridge
. Then, select
Bridging
. The Bridging
2.
Configure the Operating Mode of the MaxR-3210 Wireless Access Points.
•
MaxR-3210 (AP1) on LAN Segment 1 in Point-to-Point Bridge mode with the Remote
MAC Address of AP2.
•
Because it is in the central location, configure MaxR-3210 (AP2) on LAN Segment 2 in
Point-to-Multi-Point Bridge mode. The MAC addresses of the adjacent APs are required
in AP2.
•
Configure the MaxR-3210 (AP3) on LAN 3 in Point-to-Point Bridge mode with the
Remote MAC Address of AP2.
3.
Verify the following parameters for all access points:
•
Verify that the LAN network configuration the MaxR-3210 Wireless Access Points are
configured to operate in the same LAN network address range as the LAN devices
Figure 4-9 Wireless point-to-multipoint bridge setup
'Master' AP in
Point-to-Multi-Point
Bridge Mode
LAN
Segment 1
192.168.0.1
Router
AP in
Point-to-Point
Bridge Mode
Hub or Switch
LAN
Segment 3
AP in
Point-to-Point
Bridge Mode
LAN
Segment 2
Hub or Switch
AP1
E T H E R N E T
R E S E T
5 - 1 2 V D C
AP3
E T H E R N E T
R E S E T
5 - 1 2 V D C
AP2
E T H E R N E T
R E S E T
5 - 1 2 V D C
