Model 350AH1A
12
Rev B
2.5 AMPLIFIER OPERATION
2.5.1
CW Mode
This section describes how a single 350AH1A amplifier would be used in CW mode. A block diagram of a
typical set-up is shown in Figure 2-4,
Typical Setup–CW Mode
.
Z
Phase=0
350AH1
Load
AC
Figure 2-4. Typical Setup—CW Mode
2.5.1.1
Preliminary Settings
RF GAIN:
0%
POWER:
ON
RF ON/OFF OFF
RF Generator: 0Vrms
2.5.1.2
Level Setting
Set the RF Generator output to approximately 2Vrms. Place the unit in the RF ON mode by pressing the
RF
ON/OFF
button. Adjust the amplifier gain control for the desired output level.
CAUTION:
Do not connect or disconnect any loads or cables from the amplifier’s RF
Output when the amplifier is in the Operate mode. Dangerous voltages
that could cause serious injury to the user exist at the RF Output when the
amplifier is under power.
350AH1A
Summary of Contents for 350AH1A
