AquaTelemetry Instruction Manual
10401-01193 Rev H
1. Introduction to the Product
This manual covers the setup and operation of the AquaTelemetry Telemetry system
running software version 1.02+ in association with any LeveLine
®
Absolute Level Sonde.
1.1. What Does The AquaTelemetry System Do?
The Aquaread
®
AquaTelemetry system, when used in association with a LeveLine
®
Mini
Level Sonde forms a
data-logging and telemetry system that records water level and
temperature at pre-determined intervals then uploads the logged data periodically via email
to multiple monitoring facilities.
Instantaneous level and temperature data can be requested by SMS. The current water
level and temperature will be returned immediately by SMS. In addition, four level alerts
and one rate-of-change alert can be set to automatically send SMS messages if an alert
condition exists.
2. Setup Prior to Installation
Prior to installing the AquaTelemetry system in the field, the system must have a SIM card
fitted and it must then be set up using a PC utility.
2.1. SIM Card Fitting
Prior to installation and fitting of the main batteries, an active SIM card must be fitted to the
unit.
The SIM card must not be locked or PIN protected
. To install the SIM card, lay the
AquaTelemetry unit flat on a workbench, remove the four corner screws, then remove the
plastic cover. The SIM card socket is located at the bottom left of the circuit board.
Open the SIM card socket cover by sliding it down towards the bottom of the unit then
swinging it up. Fit the SIM card then shut the cover and lock it in place by sliding it towards
the top of the unit. See sequence of photographs below.
Make a note of the phone number registered to the SIM card.
You will need this for
setup and communication later.
© 2020 Aquaread
®
Ltd.
www.aquaread.com
Page 5 of 34
