Aquanami JETANGLER, Operator'S Manual

Page: 77 / 114

- 75 -
CAUTION:
Never flush a hot engine.
Always start the engine before opening the water tap.
Open water tap immediately after engine is started to prevent overheating.
Never run engine without supplying water to the exhaust cooling system when
watercraft is out of water.
Never run engine longer than 1 minute. Drive line seal has no cooling when
watercraft is out of water.
Always close the water tap before stopping the engine.
Running water into the flush system without the engine first running may result
in engine damage and will void the warranty.
Cooling System
Flushing Heat Exchanger
Flushing heat exchanger with fresh water is essential to neutralize corroding effects of
salt or other chemical products present in water. It will help to remove sand, salt, shells
or other particles in water jackets and/or hoses. Flushing should be performed when
the watercraft is not expected to be used further the same day or when the watercraft
is stored for any extended time. See Flushing Exhaust System above for the flushing
procedure.
Coolant
Check coolant level in coolant bottle daily before use. The coolant in the bottle should
be full. Antifreeze coolant should be replaced every 100 hours or every 12 months to
prevent antifreeze deterioration.