- 74 -
To drain the oil/water in the retainer bottle, simply pull off the hose from the middle
nozzle of the bottle, and let the water/oil drain out from the bottom nozzle through the
hose to a cup. See Engine Breathing Oil Filter and Retainer component in
WATERCRAFT AND MAIN COMPONENTS section.
Engine Drive Shaft Seal
Inspect and replace engine drive shaft seal according to Maintenance Chart. Replacing
seal may be performed by an authorized AQUANAMI dealer or repair shop.
Exhaust System
Flushing Exhaust and Heat Exchanger
Flushing the exhaust system with fresh water after each use is essential to neutralize
corroding effects of salt or other chemical products present in water. It will also help to
remove sand, salt, shells or other particles in water jackets and/or hoses. Flushing
should be performed when the watercraft is not expected to be used further the same
day or when the watercraft is stored for any extended period of time.
CAUTION:
Properly follow the instructions given in the flushing procedure.
Proceed as follows:
1. Clean ride plate with a water hose.
2. Clean jet pump by spraying water in its inlet and outlet.
3. Connect a garden hose to heat exchanger and exhaust flushing connector
located at the rear of watercraft, do not open the water tap and do not start
engine yet.
4. To flush heat exchanger and exhaust cooling system, start the engine then
immediately open water tap.
5. Run the engine about 30 seconds at a fast idle between 3000 - 4000 RPM.
6. Disconnect the garden hose first, and keep engine running another 10 seconds.
7. Stop the engine.
Summary of Contents for JETANGLER
