iSys Digital remote control
installation instructions
Page 11
Using the back plate as a template,
mark the position of the fixing
screws and a Ø16mm hole for the
data cable entry point. The cable
entry point should be made in the
top right hand corner of the back
plate recess, to ensure the two holes
are kept separate.
1
Prepare suitable wall fixings to accommodate no. 8 non-rusting
countersunk head screws of a suitable length (not included).
2
Prepare a suitable route and install the 10m low voltage data cable
leaving a working end of at least 70mm including the connector
plug. The end of the data cable closest to the splitter junction box
should terminate at a maximum of 500mm from the splitter
junction box to allow for connection to the data cable
connection block.
3
DATA CABLES MUST BE PROTECTED BY SUITABLE SHEATHING OR
CONDUIT IN THE EVENT OF SERVICING AND MAINTENANCE.
!
Pull the data cable through
before securing the back plate to
the wall using suitable no. 8 non
rusting countersunk screws.
4
