www.aquaglide.com
7
1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position
will also make launching easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note
original folding & packaging method. Remove valve cap and confirm valve is in inflate (1-way
airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use
pump to inflate Main Valve [1] to Working Pressure as shown in
Chart 1
. Check for proper
pressure using gauge (manometer). Replace valve cap.
4. Repeat step 3 instructions to inflate C-Deck boarding platform to proper Working
Pressure shown in Chart 1.
5. Anchor bridle should be properly attached
from factory. Description of proper attachment
follows for reference. Underside of bouncer
has 4 heavy duty anchor rings; one on every
other side. 4-way bridle uses 2 ropes: one long
(BLACK ends), and one short (WHITE ends).
Black ends must be attached to anchor rings on
opposite sides and white ends must be attached
on opposite sides. Tighten bridle links securely to ensure they cannot loosen or become
disconnected in rough weather. See D.
6. Confirm that suitable anchor(s) and mooring lines are in place before launching this item
(see Anchoring).
7. To launch product, lift completely and place in water. Large items may require many extra
people to accomplish this. Never drag product as damage may occur.
8. When connecting multiple items together at the waterline, always follow manufacturer’s
recommendations. Waterline connections use only Aquaglide Two-Step Vario-lock cinch
straps and connecting rings. Make sure connection is tight and there is NO GAP between
items. Failure to connect items properly may result in injury or death.
a. Attach straps to C-Deck boarding platform, included, or other ‘Connector.’
C-Deck uses 3 ring/ straps to connect to Ricochet 16.0.
b. Use all available rings to make connection. Standard connections use 5 rings.
Some items use 3 or occasionally 7 rings/ straps. Ricochet 16.0 has 5-ring sets on 2 sides
at the waterline.
c. Float C-Deck or other ‘Connector’ into desired position, typically at boarding
side (where valve and warnings are located). Note: a matching set of connecting rings is
required on Ricochet 16.0.
d. Attach center strap to center ring on Ricochet 16.0. Connect loosely, then
work outward until all straps are connected.
D
Black
Black
White
White
Bl
