Aquacal 75090, Owner'S Manual Installation And Operation

Page: 11 / 32

11
Mounting the Control Unit:
The AG power center is suitable for indoor or outdoor mounting.
When connected to 230-VAC, the power center must be installed at least 5’ (1.5 m) horizontal distance
from the pool or spa wall.
When connected to 115-VAC with a standard plug (Model 75090) power supply must be mounted at least
10’ from the pool or spa wall. Model 75090-TL has a twist-lock plug, and must be mounted at least 5’ from
the pool or spa. Both options must include a GFCI (Ground Fault Circuit Interrupter).
When using the Inline-Cell (75094) the control unit should be wired load-side to ensure the control unit
is powered on and off with the circulation pump.
1. Hold the power center chassis in the selected mounting location. Through the top, narrow portion
of mounting slots, mark the wall for the four (4) mounting holes.
2. Plastic anchors and screws have been provided for concrete or stucco walls; anchors are not required
when mounting to wood or composite materials. Drill and install the plastic anchors (as applicable).
Using a screwdriver, run the screws into the anchors, leaving a ¼” gap between the wall and the underside
of the screw heads.
3. Holding the power center slotted openings to the screw heads, allow the screw
heads to pass through the larger portion of the mount holes; hang the power
center on the four (4) mounting screws; using a long shaft screwdriver, tighten
the screws.
To avoid damage to wiring and connectors, thoroughly read the following section before proceeding:
STEP-2: The manifold will accept an RC-11 or RC35/22 residential cell; use of any other cell may
damage the power supply and the equipment warranty will be voided.
CAUTION! Use RC-11 or RC-35/22 cell ONLY. Install the cell into the manifold. Tighten the unions
by hand for a watertight seal.
All electrical connections should be made by a licensed electrician or certified electrical contractor.
INSTALLATION
Note: Insure flow rates for two-speed pump can provide sufficient flow at low
speed.
Flow Rates:
•
The manifold can be directly plumbed into the system (as shown in the diagrams
on the prior page).
•
If the flow rate for the system is less than 20-gpm (76 L/m), a larger pump must
be installed (or steps taken to improve flow rate).