6
Figure 6a
Figure 6b
Long
side of
pool
Power
Supply
NOTE: It is suggested to unplug your Power Supply when not in use to prevent accidental starts!
WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times!
WARNING: A Ground Fault Circuit Interrupter (GFCI) / Residual Current Device (R.C.D.) must be installed to
protect your electric outlet and to prevent any possible electrical shock!
2. CLEANER START POSITION
1.. Holding. the. Handle,. submerge. your. cleaner. upside.
down,.and.gently.rock.it.back.and.forth.under.the.water.
to. allow. any. trapped. air. to. escape,. which. is. critical. for.
proper.balancing.or.it.may.not.clean.and.cover.your.pool.
as.designed..
2.. While.submerged.turn.upright,.then.let.go.allowing.your.
cleaner.to.settle.to.a.level.area.on.the.pool.floor.near.the.
shallow. end.. . Starting. it. on. an. incline. (like. a. deep. end.
hopper).may.cause.the.cleaner,.program.and.sensors.to.
mistakenly.consider.the.incline.as.the.floor,.and.conversly.
on. the. floor. as. a. wall.. . . This. would. offset. its. cleaning.
program. and. coverage,. resulting. in. missed. areas.. Be.
sure.to.start.the.cleaner.on.a.level.surface.every.time.
3.. Turn.ON.Power.Supply.to.begin.cleaning.
Plug.the.Power.Supply.Cord.into.a.standard.Ground.Fault.Circuit.Interrupted.(GFCI)./.Residual.Current.Device.(R.C.D.).
protected.outlet...If.your.GFCI.outlet.is.too.far.away.and.your.cleaner.does.not.have.enough.Cable.to.properly.enter.the.
pool.at.the.midpoint.of.its.longest.side.then.you.may.use.a.proper.outdoor.grounded.extension.cord,.but.always.keep.the.
Power.Supply.at.least.12’./.4.m.from.the.pool’s.edge!
The.Power.Supply.(Fig..4).should.be.placed.in.a.sheltered.
area,.
at least twelve (12) feet / four (4) meters away from
the pool at all times
. (Fig. 6a).. . While. the. Power. Supply.
is. weather-resistant,. it. is.
not waterproof
. and. therefore.
should be placed in an elevated dry area where it will not
be allowed to sit in puddles of water.
Less. is. More:. For.
optimum. cleaning. performance. locate. the. Power. Supply.
at.the.mid-point.of.your.pool’s.longest.side.(Fig..6b)...This.
will.allow.your.cleaner.to.make.the.best.use.of.its.length.of.
Floating.Cable.without.using.excess.Cable.length...Excess.
Cable. in. the. pool. may. result. in. it. unnecessarily. twisting,.
kinking.or.getting.entangled.within.your.cleaner’s.rotating.
scrubbing. Brush. system.. . Excess. Cable. should. be. kept.
coiled.outside.the.pool.near.the.Power.Supply.
1. SETTING UP THE POWER SUPPLY
TIP!
To help protect your Cable from potentially getting twisted, it is suggested to turn off your pool’s filtration system while
your cleaner is in operation to reduce the pool’s filter circulation effect that may push and circulate the Cable.
SETTING UP YOUR ROBOTIC POOL CLEANER
