11
To Change Super Brushes for full length and “split” Wheel Tubes: (Fig. 13)
1.. Using.a.pair.of.pliers,.grab.one.end.of.the.stainless.steel.Rod.that.is.securing.
the.old.Brushes.onto.the.Wheel.Tube..Pull.away.from.the.Wheel.Tube.slowly.
until.the.entire.existing.Brush.is.freed.and.removed.(Fig..13).
2.. Wrap.the.new.Super.Brush.around.the.Wheel.Tube.
3.. Join.the.ends.of.the.replacement.Super.Brush.using.the.Metal.Rod.supplied.
in.the.package...Slide.the.Rod.through.the.Tabs.molded.into.the.ends.of.the.
Brush.(Fig..13)...Make.sure.that.the.Rod.is.inserted.through.every.Tab.
To protect against personal injury and damage to your cleaner always unplug your cleaner from its Power Supply
prior to performing any maintenance or repair procedures!
TIP!
Leave Super Brushes in direct sunlight to warm
up before mounting. They will be more pliable and
easier to work with.
Figure 13
TIP!
Lubricate the Rod with soapy water and use a pair of pliers to hold
the Rod to make it easier to insert.
CHANGING DRIVE TRACKS
Drive.Tracks.(Fig..14).may.become.worn.over.the.normal.course.of.use.and.
will.require.replacement.based.on.the.frequency.of.use,.the.pool’s.chemical.
balance,.pool.surface.and.length.of.season...Worn.(stretched,.loose.or.“flat-
spotted”).Drive.Tracks.may.effect.the.cleaning.pattern.impeding.its.ability.to.
cover. the. entire. pool.. . If. during. your. periodic. inspection. you. find. that. your.
Drive.Tracks.are.worn,.please.contact.your.Authorized Dealer for replacement
Drive Tracks .
1.. Unplug. your. cleaner. from. its. Power. Supply. and. remove. your. cleaner.
from.the.pool.
2.. Place.your.cleaner.on.its.side,.on.a.soft.surface.which.will.not.scratch.the.
Body’s.finish.
3.. With. your. thumbs. pushing. against. the. Side. Plate. (Fig.. 15),. hook. your.
fingers.under.the.Drive.Track.and.pull.it.toward.the.Side.Plate...When.you.
get.the.Drive.Track.over.the.“lip”.of.the.Side.Plate,.hold.it.there.with.one.
hand,.and.with.the.other.hand,.grip.the.Wheel.Tube.(Fig..15).and.rotate.it.
away.from.the.cleaner.until.the.Drive.Track.“walks”.over.the.Side.Plate...
Continue.this.until.the.Drive.Track.is.free.
4.. To.mount.the.new.Track,.hook.it.around.the.lower.Wheel.Tube.end.and.
pull.it.upward.as.you.guide.it.between.the.cleaner’s.Body.and.Side.Plate.
5.. Push.inward.on.the.Drive.Track.and.force.it.over.the.edge.of.the.Side.
Plate...Rotate.the.Wheel.Tube,.towards.you,.until.the.Drive.Track.
properly.seats.itself.on.the.Wheel.Tube.between.the.Side.Plate.and.the.
cleaner’s.body
6.. Repeat.steps.1.through.5.with.the.Drive.Track.on.the.other.side.of.the.
cleaner.
Figure 15
Figure 14
G-Tooth™
Drive Track
