AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO TEMECULA CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
15
WARNING
THIS FIXTURE IS DESIGNED FOR USE WITH GERMICIDAL LAMPS AND MUST BE INSTALLED IN
COMPLIANCE WITH COMPETENT TECHNICAL DIRECTION SO THAT THE USERS EYES ANDBARE
SKIN WILL NOT BE SUBJECTED TO INJURIOUS RAYS. SUITABLE FOR INDOOR, OUTDOOR, AND
DAMP LOCATIONS. DO NOT SUBMERGE IN WATER. WARNING:RISK OF ELECTRICAL SHOCK.
CONNECT O NLY T O A C IRCUIT T HAT I S P ROTECTED B Y A G ROUND-FAULT C IRCUIT
INTERRUPTER(GFCI) CAUTION: R ISK OF E LECTRICAL SHOCK. D ISCONNECT F ROM P OWER
SUPPLY BEFORE RELAMPING. CAUTION: RISK OF FIRE USE ONLY AQUA ULTRAVIOLET LAMPS IN
THE INDICATED WATTAGE SIZE. AC ONLY. MAXIMUM RATING OF 50 PSI
.
MANUF. #
SERIAL NO.
8W
A15
240W
SL400
15W
80W
S100
SL800
25W
114W
S200
SL1200
40W
120W
S300
57W
160W
SL100
A8
200W
SL200
Temecula, CA, USA
1. DISCONNECT THE HUBL CONNECTOR:
Unscrew the Hubl Connector located just above the
Transformer Cap. This will allow the transformer cap to turn without kinking the harness.
MULTI LAMP UNITS ELECTRICAL INSTALLATION
2. CONNECT THE LAMP:
Plug a Lamp into each of the Lamp End Connectors, located at the end of
the harness, one at a time. Make sure the Lamps are plugged in all the way flush with the Lamp End
Connectors. If the Lamps are not plugged in all the way it may cause damage to the unit and is not
cover under warranty.
Un
screw Ca
p
Hubl Connector
Transformer Cap
G.F.C.I
ELECTRICAL INSTALLATION
For 80, 120, 160, 200, 240 Watt Units
1. Cover Removal:
Remove the cover from the Transformer Box to allow access to screw holes
located on the back panel of the box. The cover slides down.
2. Mounting:
Mount the Transformer vertically on to a wall or other sturdy surface a minimum of 4
feet away from any dwelling. Make sure the Transformer is close enough to attach to the
UV unit.
Cover Closed
3. 220V Transformer:
Must be hard wired into a dedicated line of the appropriate voltage and
hertz.
4. 110V Transformer
: Plug into 3 prong G.F.C.I. Outlet.
Cover Open
3.
Insert the Lamp straight into the Quartz Sleeve. Be careful, inserting the Lamp at an angle, even a
slight angle, can cause a “U” shaped crack in the Quartz Sleeve. Insert one lamp at a time.
