14
Step 4 – Install Filter System Assembly
The mounting bracket contains four mounting slots. The holes are sized to accept #10 round head wood screws (supplied).
Some types of surfaces such as particle board or drywall, may require the use of plastic screw anchors or toggle bolts to
provide adequate support for the unit.
1. Tape the paper template included with this unit to the wall with the base of the template on the bottom of the cabinet
(or higher). Be sure to leave adequate space (8 1/2” or more from the centerline) on both sides of the template.
2. Drill 1/8” hole at each location as indicated on the template.
3. Remove template. Thread one of the included wood screws into each hole leaving approximately a 1/2” space
between the screw head and mounting surface.
4. Hang the bracket on the mounting screws. If unit is loose, tighten the screws further.
Install Filter Cartridges
1. Twist the cartridge to lock it into the manifold. (as shown)
Connect System
When cutting plastic tubing, use a sharp utility knife. Cut the tubing squarely. See page 8
for cutting and connecting tubing.
2. Connect 1/4-inch OD plastic tubing
from the feed water supply source
to the system inlet on the manifold.
1. Connect quick connect elbows to
the two open connection locations
on the unit. Firmly push the fittings
into place, then pull back lightly to
lock them in.
3. Connect 3/8-inch OD plastic tubing
from the product water faucet to
the manifold.
3
2
1
1/4”
3/8”
Stage 1
Sediment Filter
Stage 2
Carbon Block
Filter
Stage 3
Ultrafiltration
Membrane
Stage 4
Carbon Block
Filter
Figure 15
2
3
4
1
12"
