10
The following steps will enable you to install the system quickly and orderly. Some variation may be necessary depending
on the installation. See page 4 for a check list of tools and materials.
Typical installations follow this sequence:
1. Select Component Installation Locations
2. Faucet Installation
3. Install Adapter Valve on Water Supply
4. Install Filter System Assembly
5. Start-Up
Step 1 – Select Component Installation Locations
•
Dispenser Faucet
– The faucet is designed to be mounted on the rear lip of the sink. It may be installed in an existing
sprayer attachment hole or in a hole drilled at the time of installation. It may also be mounted to an adjacent counter
top. It should be positioned so that water is dispensed over the sink. A 7/8” diameter hole is required.
•
Important considerations:
• Access to the bottom (undersink) of the faucet is required for attachment of product water line.
• There should be no undersink obstructions which would prevent smooth tubing runs to the UF module assembly.
•
Filter System Assembly
– The filter system assembly is designed to be mounted on any rigid vertical surface such as a
cabinet sidewall, sheetrock in exposed stud. It should be positioned such that there is access to an inlet water source.
The installation should also allow convenient access for servicing.
•
Inlet Water Supply Connection
– Once a location is chosen for installation of the filter system assembly, select a nearby
cold water line to provide the water source for the system.
NOTE:
Follow all local plumbing codes when connecting to service water.
