V.1
Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 9/8/14
V.1
Patriot-AT1 Fixing Kit Installation Instructions
1.
Determine the location of the anchor
insert, allowing for the ADA compliant
clear deck space.
(SEE Figure 1, pg 4)
2.
Mark the location for the 1-1/4”
x 4” deep anchor hole. Drill a 1-1/4”
diameter, 4” deep hole at the marked
location.
3.
Dry-fit the anchor insert to make sure
it fits flush with the deck surface.
4.
Fill the hole ½ full with epoxy. Install
the anchor insert flush with the deck
surface. Allow 24 hours for the epoxy to
cure.
5.
Roll the portable cart over the
installed anchor. Align the anchor with
the fixing bar.
6.
Drop the fixing bolt into the fixing bar and start to thread the bolt into the anchor by hand.
Adjust the alignment until the bolt threads in a couple of threads by hand. This is to ensure the
bolt is properly aligned before threading with a wrench.
7.
Tighten the fixing bolt with a 3/4” wrench or socket. Tighten until the bolt is just touching
the flat washer. DO NOT OVERTIGHTEN.
You Will Need:
• Core-drilling rig
• 1-
1/4
” diameter core-drill
• 3/4” wrench
• 2-part construction epoxy
• Tape measure
• Marking pen
FIXING BOLT
( 1/2-13 X 4-1/2")
1/2" FLAT WASHER
PVC ANCHOR INSERT
BRAKE FOOT
7
