Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 9/8/14
V.1
TAB TO
FRONT
HANDSET
CABLE
MOTOR
POWER
CABLE
1
2
MAKE SURE
PLUGS ARE
FULLY SEATED
AS SHOWN
BELOW
FIGURE 2
Patriot-AT1 Assembly Instructions
6. Apply dielectic grease on the end of the handset
cord and firmly push the cord into the large outlet
on the left side of the control box. See Figure 2 to
right. It should be slightly recessed when properly
inserted.
7. Fill the ballast tank with sand (supplied by others)
as outlined in Figure 3 below. Alternate the funnel
with each fill port to make sure the sand is evenly
distributed in the ballast. Shake or tap the ballast
sides periodically to help level the sand.
8. With the counter weight now in place, deploy the
lift from the cart so the lift is in operation mode.
DO NOT OPERATE LIFT IN THE TRANSPORT MODE!
9. Operate the lift without a person in it to verify that the lift will work in the location.
Check clearances and make sure the lift seat has enough clearance between it and
the pool wall as it extends into the water.
10. Once you are
sure this is the
location you want
the lift to be, you
can install the ADA
fix kit designed to
affix the lift to the
deck as required
in commercial
applications.
REMOVE SCREWS &
CAPS FROM BOTH
HOLES TO FILL TANK.
FILL BALLAST TANK
WITH 12, 50lb BAGS OF
"ALL-PURPOSE" SAND.
OR, AT A MINIMUM, FILL
THE TANK WITH 600lbs OF
"ALL-PURPOSE" SAND.
REPLACE SCREWS & CAPS
WHEN TANK IS FILLED.
BALLAST TANK
WARNING!
DO NOT OPERATE THE LIFT
BEFORE FILLING THE BALLAST TANK
!
USE A LARGE FUNNEL
TO FILL TANK WITH
"ALL-PURPOSE" SAND
FIGURE 3
6
