V.1
Copyright © 2014 Aqua Creek Products All Rights Reserved
Revised 9/8/14
V.1
NOTE:
Assembly will require twelve (12) 50lb bags (600lbs) of sand which
is not supplied with the lift. DO NOT USE LIFT WITHOUT SAND AS A
COUNTERWEIGHT!
Patriot-AT1 Assembly Instructions
1. Remove the assembled lift from the packaging and move to the pool side.
2. Situate the lift where you want it by the pool edge (refer to page 4 for specifics). Lock
your casters and set the brake by turning the brake knob enough so the brake foot
just comes into contact with the pool deck.
3. Attach the seat belt through the loops in the seat base and pinch the hook & loop
material together. See diagram to right.
4. Apply dielectric grease on the metal tabs of the battery
and the control box on the lift.
5. Install the battery by aligning the tabs on the battery
with the tabs on the control box on the lift and snap the
battery into place. You should hear a ‘click’ when the
battery in installed properly and there should be no gap
between the battery and control box. NOTE: To extend
battery life, always store battery on the charger when
the lift is not in service.
LOOP ON TOP
FOR EASY ACCESS
THREAD THROUGH
SLOTS AND PINCH
TOGETHER TO HOLD
5
