BS - 1/2"X2 3/4"X3/8"-16 SHOULDER BOLT
PART NO. INV00455
WF - 3/8" FLAT WASHER
PART NO. INV01174
NN - 3/8"-16 NYLOCK NUT
PART NO. INV00739
1 LIFT THE EZ2 MAST ASSEMBLY FROM
THE SHIPPING CONTAINER. INSERT THE
1.90" [48mm] POST OF THE MAST
ASSEMBLY INTO THE DECK ANCHOR. EASE
THE MAST ASSEMBLY DOWN UNTIL IT
RESTS ON THE INNER SURFACE OF THE
ANCHOR. THE SQUARE MAST TUBE WILL
REMAIN ABOVE THE DECK SURFACE
APPROXIMATELY 1/2"
2 REMOVE THE BOOM ARM FROM THE
SHIPPING BOX. CONNECT THE BOOM ARM
TO THE MAST. TIGHTEN NYLOCK NUTS.
NOTE: BE CAREFUL NOT TO OVERTIGHTEN
BOLTS. OVER-TIGHTENING
CAN CAUSE DAMAGE AND COMPROMISE
THE SAFETY OF YOUR LIFT.
STEP 03-A
STEP 03-B
DETAIL STEP 03-A
SCALE 1 : 3
WF - 5/16" FLAT WASHER
PART NO. INV01176
NN - 5/16"-18 NYLOCK NUT
PART NO. INV00742
WF - 3/8" FLAT WASHER
PART NO. INV01174
BS - 3/8"X7/8"X5/16"-18 SHOULDER BOLT
PART NO. INV01870
DETAIL STEP 03-B
SCALE 1 : 3
BS - 3/8"X1 1/4"X5/16"-18 SHOULDER BOLT
PART NO. INV00461
3 REMOVE THE HYDRAULIC RAM FROM
THE SHIPPING BOX. CONNECT THE
HYDRAULIC RAM TO THE MAST AND BOOM
ARM. TIGHTEN NYLOCK NUTS.
NOTE: BE CAREFUL NOT TO OVERTIGHTEN
BOLTS. OVER-TIGHTENING
CAN CAUSE DAMAGE AND COMPROMISE
THE SAFETY OF YOUR LIFT.
Aqua Creek Products
PRODUCT ASSEMBLY
8/15/2022 12:41:43 PM PAGE - 5
