9
Quality for Professionals
To optimise the guidance of the levelling plates/harrow arrays, the feeler wheels also
have to be adjusted. This is achieved as follows:
•
Use the supplied adjustment handle.
•
Put the handle into position as shown in Fig.: 5 and clamp or fix it with the pin.
•
Remove the pin that holds the feeler wheel and use the hook to move it to the
desired position.
7
Adjustment spindle
To simplify the adjustment of the middle levelling plate, the
"Adjustment spindle accessories kit" can be purchased. To
do this, the spindle is turned up until the pins that secure the
levelling plate are relieved. Then the pins are removed and
the levelling plate can be moved to the desired depth. The
pins are inserted back into the adjustment grid and the
spindle is turned up/down until it is relieved again.
8
Maintenance and care
When the implement is lifted off of the ground, the two side wings of the frame should
be pointing slightly down. If this is not the case or if the wings are pointing down too
much, the stop bolts on the joint must be adjusted.
To maintain the implement in good condition even after a long service life, the following
instructions must be observed:
In the supplement "For your safety…" you will find some basic safety regulations
for maintenance work.
Original parts and accessories are designed especially for the machines or
implements.
Please note that parts and accessories not supplied by us have also not been
tested and approved by us.
The installation or use of such products can therefore possibly negatively change
or impede the constructional properties of your implement. The manufacturer rules
out any liability for damages resulting from the use of non-original parts and
accessories.
The manufacturer is not liable for any unauthorised modifications and the use of
components and auxiliary parts.
All bolted connections should be re-tightened at the latest after 3 operating hours
and again after 20 hours, and then checked regularly. Loose bolts can cause
significant consequential damage, which is not covered by the warranty.
The grease points on the joints and bearings must be lubricated regularly (approx.
every 10 operating hours with universal grease).
For implements with fast coupler, the guide slots must also be lubricated.
Fig.:
6
