-
19
-
English
Installation
1
2
VALUES IN MILLIMETRES
L
A
B
C
Y Max.
130 140 275
90
1200
÷
3000
C1
AP030008
C2
C3
3
2
4.1 PREPPING FOR THE REAR MOUNTING
4.1.1 Operator fi xed on iron posts
If the gate supporting posts are made of iron, it is necessary to
fi
t a reinforcing plate for welding the rear operator mounting.
Perfectly clean the welding zone for the rear mounting with the special tool (
C2
pos.
1
); make sure to remove any traces of paint
or zinc coating.
Position the reinforcing plate (
C3
pos.
2
) in the rear mounting welding zone and weld it on the column, covering it from edge to edge.
The size of the reinforcing plate must be in proportion to the size of the column.
Warning
!
• If the size of the column allows for it, use the Aprimatic
standard plate provided.
4.1.2 Operator
fi
xed on wooden posts
If the gate supporting posts are made of wood, it is necessary to
fi
t
a reinforcing plate on the column, covering it from edge to edge, in
the rear mounting welding zone. The plate shall be
fi
xed
fi
rmly on the
column by means of
fi
xing screws (
C4
).
The size of the reinforcing plate must be in proportion to the size
of the column.
Warning
!
• If the size of the column allows for it, use the Aprimatic
standard plate provided.
4.1.3 Operator
fi
xed on masonry posts
If the supporting posts for the gate leaves are made of masonry,
fi
x
the special metal plate complete with anchor bolts used to weld on
the rear mounting of the operator to each of them.
Preparing the insets
If mounting insets have to be made in the posts for the rear operator
mounting with metal plates, the measurements shown in fig.
C6
must be adhered to.
Warning
!
Remember that the inset is necessary when the distance between
the edge of the post and the centre of rotation of the gate leaf is
greater than the distance
Y
(C1), or when the gate leaf is anchored
to a continuous wall.
Fixing the anchoring plates
Fig. C5 shows some
fi
xing examples by means of different types
of plates:
A -
Plate with hooked
fi
tting
B -
Plate with stud bolts, either glued or pressure-
fi
tted
C -
L-plate with stud bolts, either glued or pressure-
fi
tted
C5
C4
min 5 mm
*
CUT TO MEASURE
(not supplied by APRIMATIC)
min 5 mm
min 5 mm
B
APRIMATIC
(standard)
A
APRIMATIC
(optional)
C
*
1) Wing rotation axis
2) Operator centre of rotation
