69
use and maintenance
Scarabeo 250
R
u
Press the bulb (3) slightly and rotate it
counter clockwise.
NOTE
If the bulb holder (4) comes off,
refit it into its seat so that the slotted
opening of the holder matches the hole for
the screw.
u
Extract the bulb from its seat.
NOTE
Insert the bulb into the bulb
holder, so that the two pins slide into the
slots in the holder.
u
Fit a new bulb of equal rating.
Upon reassembly:
NOTE
Make sure that the lens (2) is
positioned correctly into its seat when fit
back.
Tighten the screw (1) gradually. Do not
o v e r t i g h t e n o r t h e s h i e l d ( 2 ) w i l l
damage.
C H A N G I N G T H E H E A D L I G H T
BULBS
Carefully read page 68 (BULBS)
The headlight fits:
– One low/high beam bulb (1).
– One parking light bulb (2).
To change the bulbs:
u
Release and remove the screw (3).
NOTE
Upon reassembly, take care not
to reverse the position of the screws (3)
and (4).
u
Release and remove the screws (4).
u
Remove the frame (5).
u
Remove the reflector (6).
NOTE
Upon reassembly, install the
reflector (6) correctly, matching the
insertion seats.
LOW/HIGH BEAM BULB
(HALOGEN BULB)
Never pull on the wiring to disconnect a
bulb connector.
u
Grasp the bulb connector (7) and pull to
disconnect it from the bulb (1).
u
Position the bulb holder (8) in the
reflector and rotate it clockwise.
u
Remove the bulb (1).
Upon reassembly:
NOTE
Insert the bulb (1) in the holder,
making the two bulb pins (9) match with the
relevant guides (10) on the reflector seat.
u
Position the bulb holder (8) in the
reflector and rotate it clockwise.
u
Connect the bulb electric connector (7).
Scarabeo250USA.book Page 69 Friday, July 22, 2005 6:17 PM
