APRILIA PEGASO 650 IE - 2003, Manual

Page: 43 / 112

43 use and maintenance Pegaso 650 I.E.
02%,)-).!29 #(%#+).' /0%2!4)/.3
Component Check Page
Front and rear disc
brakes
Check the functioning, the idle stroke of the control levers, the fluid level and make
sure there are no leaks.
Check the wear of the pads.
If necessary, top up the fluid tank. 29 (BRAKE FLUID - recommendations), 30
(DISC BRAKES), 31 (FRONT BRAKE), 33
(REAR BRAKE), 80 (CHECKING THE
BRAKE PAD WEAR)
Accelerator
Make sure that it works smoothly and that it is possible to open and close it com-
pletely, in all steering positions. If necessary, adjust and/or lubricate it. 82 (ADJUSTING THE ACCELERATOR
CONTROL)
Engine oil Check and/or top up if necessary.
37 (ENGINE OIL), 59 (CHECKING THE
ENGINE OIL LEVEL AND TOPPING UP)
Wheel/tyres
Check the tyre surface, the inflation pressure, wear and tear and any damage.
Remove any foreign matter that may be stuck in the tread grooves.
36 (TYRES)
Brake levers
Make sure that they work smoothly.
Lubricate the articulations and adjust the stroke if necessary.
39 (ADJUSTING THE REAR BRAKE
CONTROL LEVER CLEARANCE)
Clutch
The idle stroke at the end of the clutch lever must be approximately 10 mm; the clutch
must work without jerking and/or slipping.
38 (CLUTCH)
Steering Make sure that the steering rotates smoothly, without any clearance or slackening. –
Side stand and
centre stand
m
(supplied as
standard equipment
in the countries
where required)
Make sure that it operates correctly. Make sure that when the stand is let up or down
there is no friction and that the spring tension brings it back to its normal position.
If necessary, lubricate joints and hinges.
Make sure that the safety switch operates correctly.
86 (CHECKING THE STAND), 91
(CHECKING THE SWITCHES)
Fastening elements
Make sure that the fastening elements are not loose. If necessary, adjust or tighten
them.
–
Drive chain Check the slack. 70 (DRIVE CHAIN)
Fuel tank
Check the fuel level and top up, if necessary.
Check the circuit for leaks.
Make sure that the fuel cap is correctly closed.
27 (FUEL)
Coolant
The coolant level in the expansion tank must be included between thmax e “ MAX ”
and “ MIN ” marks.
34 (COOLANT), 35 (CHECKING AND
TOPPING UP)
Engine stop switch
(
2
-
1
)
Make sure that it operates correctly. 19 [ENGINE STOP SWITCH (
2
-
1
)]
Lights, warning lights
LED, horn, rear
brake light switch
end electric devices
Check the proper functioning of the acoustic and visual devices. Change the bulbs or
intervene in case of failure. 87 (BATTERY) – 97 (CHANGING THE
NUMBER PLATE BULB)