APRILIA 8140172, Service And Repair Manual

Page: 36 / 279

SERVICE AND SETTING UP
2 - 9
RSV mille
SERVICE DIAG V BATT
1
2
2.3.6 STANDARD SETTING: COOLANT
TEMPERATURE AND DIGITAL CLOCK
The coolant temperature value (1) is shown in the upper
part of the right display.
It is possible to switch from °C to °F and viceversa, see
2.3.10 (SETTING °C OR °F).
– When the temperature is below 35°C (95°F), the writ-
ing “
×
” (1) blinks on the right display.
– When the temperature is over 115°C (239°F), the value
(1) blinks on the right display, even if a function differ-
ent from the standard setting has been set.
– When the temperature is over 130°C (266°F), the writ-
ing “
///
” (1) appears on the right display.
NOTE
If the writing “LLL” is displayed with a tempera-
ture below 130°C (266°F), there may be a failure of the
electric circuit, see 6.10.3 (COOLANT TEMPERATURE
DISPLAY).
Thermometer range on the display:
35 – 130°C (95 – 266 °F).
The digital clock (2) appears in the lower part of the right
display.
To set or modify hour and minutes, see 2.3.8 (SETTING
THE HOUR) and 2.3.9 (SETTING THE MINUTES).
2.3.7 BATTERY VOLTAGE - VBATT
◆ If the push button
D
is pressed once, the battery volt-
age expressed in volt (3) appears in the lower part of
the right display, while the coolant temperature (1) is
displayed in the upper part.
The writing “V BATT” (4) is displayed.
The recharge circuit functions correctly if at 4000 rpm
the battery voltage with low beam on is included be-
tween 13 and 15 V.
2.3.8 SETTING THE HOUR
◆ When the push button
D
is pressed for the second
time, the hour segments (5) start blinking in the lower
part of the right display (digital clock).
◆ To modify the hour setting, press the “LAP” push button
(6) on the left part of the handlebar.
◆ To confirm the hour setting, press the push button
D
.
2.3.9 SETTING THE MINUTES
◆ When the push button
D
is pressed for the third time,
the minute segments (7) start blinking in the lower part
of the right display (digital clock).
◆ To modify the minute setting, press the “LAP” push but-
ton (6) on the left part of the handlebar.
◆ To confirm the minute setting, press the push button
D
.
2.3.10 SETTING °C OR °F
◆ When the push button
D
is pressed for the fourth time,
the segments of the coolant temperature in °C or °F (8)
start blinking in the upper part of the display.
◆ To modify from °C to °F setting, or vice versa, press the
“LAP” push button (6) on the left part of the handlebar.
◆ To confirm the setting, press the push button
D
.
SERVICE DIAG V BATT
3
4
6