FUEL SUPPLY SYSTEM
4
- 17
RSV mille
4.8.5 REFITTING THE THROTTLE BODY
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
a
CAUTION
After disassembling the throttle body, replace all the
gaskets, O-rings, torsion springs, bushes and seals.
These components are supplied with the repair kit.
◆
Fit the new O-rings (1) and seals (2) on both injector.
◆
Insert the injector (3) in the left injector support (4) and
in the right injector support (5).
◆
Fit the left injector support gasket (6), right injector sup-
port gasket (7) and the two seals (8) on the throttle
body.
◆
Install the complete left injector support (4) and right in-
jector support (5) in the throttle body, fastening them
with the new M6x25 screws respectively (9 - 10).
Driving torque of screws (9 - 10): 9 Nm (0.9 kgm).
◆
If the synchronizing screws (11) and respective O-rings
(12) have been replaced, screw on the screws (11) fair-
ly tight until they touch the stop and then unscrew them
a single turn.
Presetting of synchronizing screws (11): 1 turn.
a
CAUTION
The precise adjustment of the screws (11) must be
performed using a vacuum gauge, see 4.8.10 (CYLIN-
DER SYNCHRONIZATION).
◆
Fasten the fuel pressure regulator (13) using the two
M6x16 screws (14).
Driving torque of screws (14): 3.5 Nm (0.35 kgm).
NOTE
Smear a film of grease over the surfaces of the
fulcrum pin (18), see 1.6 (LUBRICANT CHART).
◆
Insert the cold-start lever (15), torsion spring (16) and
shaft sealing ring (17) on the fulcrum pin (18).
◆
Insert the complete fulcrum pin (18) in the throttle cable
support bracket.
NOTE
Make sure the torsion spring is hooked to the
cold-start lever (15) and cable support bracket.
◆
Spray chain grease onto the spring (16), see 1.6 (LU-
Summary of Contents for 8140172
