APRILIA 1996 PEGASO 650, Manual

Page: 52 / 74

52 use and maintenance Pegaso 650
)$,).' !$*534-%.4
Carefully read p. 36 (MAINTENANCE).
Adjust the idling every time it is irregular.
To carry out this operation, proceed as fol-
lows:
U
Ride for a few miles until reaching the
normal running temperature, see p. 15
(Coolant temperature indicator “
h
”).
U
Keep the vehicle in vertical position, with
both wheels resting on the ground.
U
Check the engine idling rpm on the revo-
lution counter.
The engine idling speed must be about
1400
±
100 rpm.
If necessary:
U
Adjust the knob (1) positioned on the left
side of the vehicle.
By SCREWING IT (clockwise), you in-
crease the engine rpm.
By UNSCREWING IT (anticlockwise),
you decrease the engine rpm.
U
Twist the throttle grip, accelerating and
decelerating a few times to make sure
that it functions correctly and to check if
the idling speed is constant.
Do not adjust the air screw, to
avoid variations of the carbura-
tion setting.
If necessary, contact your
APRILIA
Offi-
cial Dealer.
!$*534).'
4(% !##%,%2!4/2 #/.42/,
Carefully read p. 36 (MAINTENANCE).
The ideal slack of the accelerator control
should be about 2-3 mm.
To adjust the slack, proceed as follows:
U
Remove the protection element (2).
U
Loosen the nut (3) (by screwing it).
U
Act on the adjuster (4) placed at the be-
ginning of the accelerator control cable.
Once you have carried out the adjustment,
tighten the nut (3) (by unscrewing it), thus
locking the adjuster (4) and put back the
protection element (2).
!$*534).'
4(% #/,$ 34!24 #/.42/,
e
Carefully read p. 36 (MAINTENANCE).
The ideal slack of the cold start control
should be about 2-3 mm.
To adjust the slack, proceed as follows:
U
Remove the protection element (5).
U
Loosen the nut (6) (by screwing it).
U
Act on the adjuster (7) placed at the be-
ginning of the accelerator control cable.
Once you have carried out the adjustment,
tighten the nut (6) (by unscrewing it), thus
locking the adjuster (7) and put back the
protection element (5).
c