APRILIA 1996 PEGASO 650, Manual

Page: 15 / 74

15 use and maintenance Pegaso 650
).3425-%.43 !.$ ).$)#!4/23 4!",%
Description Function
Direction indicator
warning light
c It blinks when the direction indicators are on.
Neutral indicator warning light
q
It comes on when the gear is in neutral.
Engine oil pressure
warning light
j
It comes on every time the ignition switch is brought to position "
n
" and the engine is not run-
ning, thus checking the proper functioning of the lamp. If during this phase the lamp does not
turn on, it must be replaced. The warning light must go off when the engine is running.
If the warning light comes on during the normal running of the engine, this
means that the oil pressure in the circuit is insufficient. In this case, immediate-
ly stop the engine and contact your
APRILIA
Official Dealer.
High beam warning light
a It comes on when the headlight is in "high beam" position or when the high beam signalling is
operated.
Parking light
and low beam warning light
p It comes on when the lights are on.
Low fuel warning light
g It comes on when the quantity of fuel left in the tank is about 6
L
(electrical reserve).
In this case, provide for immediate topping up, see p. 21 (FUEL).
Revolution counter
It indicates the number of revolutions of the engine per minute.
Never exceed the engine max. rpm, see p. 34 (RUNNING-IN).
Total kilometres odometer It indicates the total number of kilometres covered.
Speedometer It indicates the driving speed.
Coolant temperature indicator
h
It indicates the approximate temperature of the coolant in the engine. When the pointer starts
moving beyond level "40", the temperature is sufficient for driving the vehicle. The normal
running temperature range is indicated by the graduated area of the scale. If the pointer
reaches the red area, stop the engine and check the coolant level, see p. 26 (COOLANT).
If the maximum allowed temperature is exceeded (red area of the scale), the en-
gine may be seriously damaged.
Partial kilometres odometer It indicates the partial number of kilometres covered. To set it to zero, use the odometer trip control.
Odometer trip control Rotate it anticlockwise to set the partial kilometres odometer to zero.
a
a
a