API AP-3580, Manual

Page: 16 / 24

16
LED Calibration
The LED Calibration is performed to set the brightness of the individual LEDs.
Follow the Cleaning procedure on page 21 to clean the light chamber and optic
lenses.
1. Tap to go to settings.
2. Tab
Calibration .
3. Tap LED Cals .
4. Remove the Meter Check Disk (Code 1705-EU) from the foil pouch. DO NOT
remove the black cover from the disk.
5. Insert the Meter Check Disk. Close the lid.
6. Tap
Start to begin the meter check procedure.
7. When the calibration is complete the message “LED Calibration Complete”
will appear.
8. Tap to return to the Testing Menu and resume testing.
Angle Calibration
Angle Calibration checks the alignment of the hub and disk. The results are
analyzed and reported as pass or fail. If the measurements pass the settings will be
saved. If the analysis fails, contact Support.
If performing the LED Calibration and the Angle Calibration, the LED Calibration
should be performed before the Angle Calibration.
Follow the Cleaning procedure on page 21 to clean the light chamber and optic
lenses.
1. Tap to go to settings.
2. Tab
Calibration .
3. Tap Angle Cals .
4. Remove the Meter Check Disk (Code 1705-EU) from the foil pouch. DO NOT
remove the black cover from the disk.
5. Insert the Meter Check Disk. Close the lid.
6. Tap
Start to begin the meter check procedure.
7. If the meter is performing satisfactorily, “Angle Calibration Successful” will
be displayed and the settings will be saved. If the meter is not performing
satisfactorily, “Angle Calibration Unsuccessful. Contact Support” will be
displayed.
8. Tap to return to the Testing Menu and resume testing.
AQUASPIN WEB APPLICATION ASSISTANCE
For questions or comments regarding API AQUASPIN website or reordering
AQUASPIN disks, please contact: Mars Fishcare by calling 1-800-847-0659 or by
emailing APITechServices@effem.com.
For meter troubleshooting, please contact: LaMotte Company by calling
1-800-344-3100 ext. 3 or by emailing softwaresupport@lamotte.com.