API AP-3580, Manual

Page: 11 / 24

11
The API AQUASPIN meter can log test results for 250 water samples in the Test
History. The results for the most recent sample will be located at the top of the list.
All results can be logged automatically, or results for an individual sample can be
logged manually after the sample has been tested.
To turn on automatic logging, tap on the Test Screen. Tap . Select Auto-Save
Tests. Tap and
at t t t t t t t t ic
to return to the test screen. When Auto Save is selected will
not be highlighted on the Test Results screen.
To manually log results for one sample at a time, Auto-Save Tests must be disabled.
If Auto-Save Tests is disabled will be highlighted on the Test Results screen. After
the test has been run, tap to save the results for that water sample to the Test
History.
Select All/
De-Select
All
00:35 23-May Fresh Q104
00:22 23-May Fresh Q104
21:44 23-May Fresh Q104
21:43 23-May Fresh Q104
20:41 22-May Fresh Q104
20:36 22-May Fresh Q104
Test History
View
Selected
Results
Delete
Selected
Results
History
Settings
Select
Auto Save
Go to Top
Go to Bottom
Scroll up
or down
the test
list by 5
entries
Home
Logged results are viewed in Test History. Controls for viewing and managing single
or multiple test records are located on the Test History screen. Tap the checkbox
next to a test record to select it, then tap one of the buttons along the bottom to
perform an action with the selected records.
If the
!
symbol is displayed the default blank was used because the disk was
under fi lled or there was an air bubble.
SYRINGE
A plastic syringe is used to fi ll the disks. A precision tip on
the syringe fi ts into the fi ll hole on the disk. The syringe tip
should not be removed from the syringe. Syringes should be
cleaned between water samples. Pump air in and out of
the syringe a few times to clear the previous sample, or rinse
the syringe with a small amount of the next water sample
before fi lling it with the next sample.