PCH cold storage generator module
APEN GROUP SPA reserves the right to contribute the necessary modifications to the documentation or documentation
18
cod. HG0130.05GB ed.B-2104
PCH
19
cod. HG0130.05GB ed.B-2104
PCH
HG0130.00 A
013
HG0130.00 A
012
HG0130.00 A
011
Heating and Conditioning Solutions
ESP
DISEGNO
DESCRIZIONE
1:10
Classe di Tolleranza
ISO 2768 - M
DISEGNO DI PROPRIETA' APEN GROUP spa E' VIETATA LA RIPRODUZIONE E LA DIFFUSIONE ANCHE PARZIALE SENZA L'AUTORIZZAZIONE DELL'APEN GROUP spa
ISO 2768 - C
CAR
TIG
LIO
c
od
. X
07003 e
d.0411
-
MO
DI
FI
CA AP
PR
OVA
TA D
A
-
APPROVATO DA
-
-
-
17/03/17
-
MROSSI
DA
TA
M
ODI
FI
CA
MO
DI
FI
CA
D
IS
EG
NA
TA
DA
-
DE
SCR
IZ
IO
NE
M
ODI
FI
CA
ESP
PCH065IT.03
GENER.PCH065 CONDENSAZIONE VER03
DATA
DISEGNATO DA
-
MATERIALE
ApenGroup
®
SCALA
Quote senza indicazione di
tolleranza:
per lavorazioni in tranciatura
(flue discharge)
Scarico fumi Ø 80
(air inlet)
Aspirazione aria Ø 80
Alimentazione gas G 3/4"
(gas pipe)
Ingresso cavi elettrici
(electrical cables inlet)
Scarico condensa G 1/2"
(condensate drain)
90
449
640
592,
09
120
730
1245
449
48
≥ 400 mm
---------------------------------------------------------------------------------
ATTENTION: The "B" type terminal fitting must be installed
on the intake terminal keeping the air intake side without
holes facing upwards. During installation, special attention
must be paid to the air flow direction through the PCH heater
after the latter is fitted inside the air handling or roof-top unit.
------------------------------------------------------------------------------------
---------------------------------------------------------------------------------
ATTENTION: Correctly position the intake terminal, with
the pipe connection notch facing upward to ensure the
correct operation of the PCH heater.
---------------------------------------------------------------------------------
Accessories supplied as standard to correctly install the
PCH heater.
---------------------------------------------------------------------------------
ATTENTION: Correctly position the intake terminal
for
the "B23" type application by fitting the internal cylinder
over the "C" type intake terminal, with the side without
hole facing upward to ensure no water can directly enter
into the heater (this application makes the equipment
IPX5).
---------------------------------------------------------------------------------
"Blind" side ALWAYS facing upwards
Front minimum distance for the correct installation of the
PCH heater.
