Page 15
GENERAL
INFORMA
TION
AM
ER
IC
AN
P
ILE
DRIVING E
QU
IP
M
EN
T
J&
M
F
O
UN
DAT
ION EQ
UIP
M
EN
T
MODEL 20-5 HIH
Copyright © 2022 American Piledriving Equipment Inc. All Rights Reserved
800-248-8498
800-248-8498
WWW.AMERICANPILEDRIVING.
WWW.AMERICANPILEDRIVING.
com
com
Hammer Controls
Wireless Pendant
POWER / EMERGENCY STOP
ATTENTION
NOTE
:
“WHILE DRIVING”
If remote is out of range, Drive will go into neutral, Engine rpm will decrease to idle, and if clamp is active, clamp will stay closed.
IF EQUIPPED
key features
GOVERNOR
ENGINE RPM DOWN
Press to decrease RPM by increments of 50
RPM. Hold for Min RPM.
DRIVE STOP
Press DRIVE STOP button to ENGAGE
(AUTO MODE)
DWELL DECREASE
Press DWELL DOWN button to decrease
dwell time (AUTO MODE)
ENGINE
START/STOP
START
Press Engine Start button to start
ENABLE BUTTON IS REQUIRED
STOP
Press Engine Stop button to shut
down the engine
GOVERNOR
ENGINE RPM UP
Press to increase RPM by increments of
50 RPM. Hold for Max RPM
DRIVE START
Press DRIVE START button to ENGAGE
ENABLE BUTTON REQUIRED
ENABLE BUTTON
Must be depressed to activate a function:
ENGINE START
DRIVE START
AUTO / MANUAL
EMERGENCY STOP:
WILL SHUT OFF
ENGINE, DISENGAGE
DRIVE AND ALL
VALVES INSTANTLY
.
Control panel will stay on.
ATTENTION:
POWER
E-STOP
AUTO/MANUAL
Press AUTO / MANUAL button to toggle
between modes.
ENABLE BUTTON REQUIRED
BLUE LED
= AUTO MODE ACTIVE
•
Wireless Remote
•
USB Magnetic Charging Dock
•
Range Distance up to 600’
•
Rugged Heavy Duty
•
Ergonomic Handheld
•
Waterproof
•
Shockproof
•
High-Impact Rated
•
Engine Display
•
Hydraulic Display
•
Extended Battery Life
STROKE DECREASE
Press STROKE DOWN button to decrease
stroke time (AUTO MODE)
AUTO MODE:
1.
Press Enable Drive Start button = Starts hydraulic flow to the HIH Manifold (nothing
moves)
2.
Press Enable Drive Start button = HIH enters cycle mode. (Stroke and Dwell is active)
MANUAL MODE:
1.
Press Enable Drive Start button = Starts hydraulic flow to the HIH Manifold (nothing moves)
2.
Press Enable Drive Start button = Hammer lifts while holding.
3.
Release Drive Start button to let hammer fall. (Stroke and Dwell is not active)
STROKE INCREASE
Press STROKE UP button to increase
stroke time (AUTO MODE)
DWELL INCREASE
Press DWELL UP button to increase dwell
time (AUTO MODE)
AUTO MODE:
Continuous cycle of preset stroke and dwell time.
MANUAL MODE:
Only raises the ram while the user depresses the
drive start button.
STROKE:
Adjust the stroke time from 0-100% in 5% increments. Full
stroke is approximately 90% stroke time.
DWELL:
Adjust the time between the weight impact and the next lift
cycle. The ram must come to a complete rest before the lifting cycle begins.
