10
6.3.2 ATTEMPTING TO START
Switch on the Power Pack by pressing the ON/OFF switch. Start the motor. Do not operate the starter for longer than 6 seconds. The
battery of the Power Pack is not designed for longer starting attempts. Pause for at least 5 minutes between two starting attempts.
If the motor does not start after three attempts, abort the process and investigate the cause of the defect.
6.3.3 REMOVING THE POWER PACK
First disconnect the black (-) pole calliper and attach the pole calliper to the designated holder. Then disconnect the red (+) pole
calliper and attach the pole calliper to the designated holder. Always maintain this sequence.
Recharge the Power Pack.
6.4 USE AS 12 V VOLTAGE SUPPLY
The Power Pack can be used as a 12 V direct current source for many devices that can be operated with 12 V direct current and a
cigarette lighter plug. Plug the cigarette lighter plug of the device you wish to operated into the 12 V outlets (Position 6 in the
overview). The device you wish to operate should not require a current greater than 10 A.
6.5 USE AS A USB CHARGER
Thanks to the USB port (Position 11 in the overview), the Power Pack may also be used as a charger for mobile telephones,
smartphones, tablets, MP3 players and similar devices. To recharge a USB device, first connect it with the associated charging cable
(not included in the scope of delivery). Plug the USB plug on the charging cable into the USB port on the Power Pack. Start charging
by pressing the ON/OFF switch (Position 8 in the overview).
6.6 LED INDICATOR FIELD
The Power Pack has an LED indicator field. This can be used either as a work light or a warning light. Hold down the ON/OFF switch
(Position 8 in the overview) until the work light switches on. Pressing the switch once again turns off the warning light (flashing),
and pressing yet again turns the LED indicator field off completely.
6.7 COMPRESSOR
In order to be able to work with the compressor, first remove the air hose from the storage compartment (Position 16 in the
overview).
To fill, switch the compressor on using the ON/OFF switch (Position 12 in the overview).
The manometer (Position 13 in the overview) is used to give a rough approximation of the air pressure. When the desired air pres-
sure is reached, switch the compressor off. Remove the valve connection in reverse order (Figures 5 – 2).
6.7.1 FILLING A TYRE USING THE CAR VALVE (SCHRADER VALVE)
Open the lock on the
valve connection
Place the valve connection
on the valve
Lock the valve connection
You can now fill the tyres
using the compressor
Figure 3
Figure 4
Figure 2
Figure 5
6.3.1 CONNECTING THE POWER PACK (VEHICLES WITH NEGATIVE EARTH)
Make sure that the Power Pack is switched off, the charge status display must not light up. The Power Pack switches itself off after
around 10 seconds when not in use. Wait until the Power Pack has switched off before continuing.
Switch off the ignition and all electrical consumers of the vehicle (radio, lights, rear window heating, seat heating etc.). Apply the
parking brake.
First connect the red (+) pole callipers (Position 17 in the overview) to the plus terminal of your vehicle battery. The black (-)
pole callipers (Position 15 in the overview) is connected, as far as possible from the battery, to the motor block or chassis (not to
a painted part).
Summary of Contents for 16553
Page 27: ...27...
