11
6.4 Charging USB devices
6.5 Using the 12V output
6.6 Using the LED lights / signal lights
Read the vehicle manual to find out what voltage you need to use for a jump-start.
Make sure that the power pack is fully charged. Recharge the power pack if necessary. Switch off the vehicle ignition and all
electrical consumers, such as lights, radio, seat heating, etc. Check if the battery poles of your vehicle battery are free from
contamination or oxidation. Connect the red (+) positive cable of the power pack to the plus pole of your vehicle battery.
Connect the black (-) minus cable to the minus pole of the vehicle battery. Ensure that all connections are correct. Press the
„Override“ switch (position 6 in the overview) and then the switch for the battery voltage suitable for your vehicle for at least 2
seconds: 12V switch (position 8 in the overview), 24V switch (position 7 in the overview). The display now shows “JUMP START
READY” at the selected voltage, Fig. 8.
Connect the USB device to the USB output on the power pack which suits your device (position 9 or 10 in the overview). Push the
ON switch of the power pack (position 5 in the overview) to start charging. When charging is complete, remove the USB device
from the power pack’s USB output. The power pack will switch off after approx. 30 seconds.
Connect your 12V device to the 12V power output (position 13 in the overview) with a 12V vehicle plug. Push the ON switch
(position 5 in the overview) to start charging. After use, switch off your 12V device and remove the plug from the 12V output of
the power pack. The power pack will switch off after approx. 30 seconds.
Um das Dauerlicht der LED-Leuchte (Position 14 in der Übersicht) einzuschalten, halten Sie den EIN-Schalter (Position 5 in der
Übersicht) des Powerpacks für ca. 3 Sekunden gedrückt. Danach können Sie durch erneutes Drücken des Schalters die folgenden
Lichtfunktionen hintereinander einschalten: Blinken, SOS, aus.
Start the motor of your vehicle within 30 seconds. Do not operate the starter for longer than 5-8 seconds. If the start attempt
is not successful, wait for at least three minutes before the next attempt. After the third failed attempt, do not attempt again.
Instead, check your vehicle for faults.
After the engine is running first remove the black (-) minus cable from your vehicle battery and then the red (+) positive cable.
Recharge the power pack after each jump-start.
WARNING:
There is always a voltage without fuse on the pole callipers in the „Override“ mode.
Fig. 8 Jump-start “Override”, 12V
