1. Circuit breaker
The function of circuit breaker is to protect welding machine and operator by automatic trip to turn-off power
supply when overload or short circuit happens to the power source. Normally, the switch flipped to upward means
power-on. To start or stop the welding machine is done by the mains switch in the distribution box. Please do not
take this circuit breaker as the power switch.
2. Input power cable
It is 4-pin cable. The mixed-colored wire must be firmly grounded, the rest wires connect to corresponding 3-phase
power supply.
3. Nameplate
4. Cooling fan
Cool down the heat components in the welding machine.
5. Earthing bolt
To ensure operators not being harmed and welding machine working normally, make sure the earthing bolt is
grounded firmly by protective GND wire, or make sure the
wire (mixed-colored) of the power
supply cable is grounded firmly.
protective GND
5-4 Connections
Output socket
The output socket of this power source has two types: one is fast plug-in type, another one is compression type.
Make sure the plug match your power source socket.
Fig. 5-4-1: Output socket
5-5 Installation and operation
Warning! Electric shock is very dangerous. If the machine is plugged into the mains electricity supply
during installation, there is a high risk of very serious injury and damage. Only carry out work on the
machine when
- the mains switch is in the “OFF” position,
- the machine is unplugged from the mains.
Compression type
Fast plug
-
intype
25
