
22
1.2 Establish the wireless link between successive handheld units and the same cradle.
Step 5.0
Please refer to instruction in previous section to pair the cradle with the first handheld unit.
Step 6.0
Repeat steps 3.0
~
3.3 to set radio address of the second handheld unit.
Step 7.0
Scan JOIN barcode to pair the second handheld unit with the cradle.
)
The blue LED on the handheld unit will blink to indicate that the handheld unit is ready to be positioned
onto the cradle.
Step 7.1
Firmly position the handheld unit onto the cradle. Within 10 seconds, two beeps will be emitted to
signal that the cradle has been paired to the handheld unit, and the blue LED on the handheld unit will go off.
If three beeps are emitted, it indicates unsuccessful pairing between the cradle and the handheld unit; then
repeat steps 7.0
~
7.1.
Step 8.0
Repeat steps 6.0
~
7.1 to pair the third, the fourth, … the nth handheld unit with the cradle.
)
One single cradle can pair with up to 16 handheld units.
1.3 Verify the success of configuration
Please refer to the chapter of “Return default parameters, version and wireless communication
information” to verify the success of configuration.