21
Distributed coordination wireless communication setting
1. Cluster establishment example
1.1 Establish the wireless link between the cradle and the first handheld unit.
Step 1.0
Please refer to chapter “return default parameters & version chapter” to check the current wireless
network topology. If it is point coordination network topology
，
please scan the optional barcode 0700 and
0800 to change the network topology.
Step 2.0
Scans the following barcode to return to default parameters.
)
This step can be omitted.
Step 3.0
Scan the following barcode to start configuring handheld unit.
Step 3.1
Scan the following barcode to assign an address to a handheld unit.
Step 3.2
Scan four digits as an address.
)
All handheld units used in the same area must have different addresses.
+
Four digits for the handheld unit address
（
From 0000 to 1999
）
For example
：
Step 3.3
Scan the following barcode to complete the configuration.
Step 4.0
Scan the following barcode to bind the handheld unit with the cradle.
)
The blue LED on the handheld will blink to indicate that the handheld unit is ready to be positioned onto
the cradle.
)
Scan BIND barcode to pair the handheld unit and the cradle. The handheld unit is dedicated to the cradle.
Any previous bound handheld units will be excluded.
)
If the cradle in not bound to a handheld unit, its address assumes a random value which can cause conflicts
and malfunctions to other cradles within it range.
Step 4.1
Firmly position the handheld unit onto the cradle. Within 10 seconds, two beeps will be emitted to
signal that the cradle has been paired to the handheld unit, and the blue LED on the handheld unit will go
off. If three beeps are emitted, it indicates unsuccessful pairing between the cradle and the handheld unit;
then repeat step 4.0.