AOpen 1557, User Manual

Page: 88 / 106

6 Troubleshooting 78
02F0: CPU ID: CPU socket number for Multi-Processor error.
02F4: EISA CMOS not
writeable* ServerBIOS2 test error: Cannot write to EISA CMOS.
02F5: DMA Test Failed* ServerBIOS2 test error: Cannot write to extended DMA
(Direct Memory Access) registers.
02F6: Software NMI Failed* ServerBIOS2 test error: Cannot generate software NMI
(Non-Maskable Interrupt).
02F7: Fail-Safe Timer NMI
Failed* ServerBIOS2 test error: Fail-Safe Timer takes too long.
device Address Conflict Address conflict for specified device .
Allocation Error for: device Run ISA or EISA Configuration Utility to resolve
resource conflict for the specified
device .
Failing Bits: nnnn* The hex number nnnn is a map of the bits at the RAM
address which failed the memory test. Each 1 (one) in
the map indicates a failed bit. See errors 230, 231, or
232 above for offset address of the failure in System,
Extended, or Shadow memory.
Invalid System
Configuration Data Problem with NVRAM (CMOS) data.
I/O device IRQ conflict I/O device IRQ conflict error.
One or more I2O Block
Storage Devices were
excluded from the Setup
Boot Menu There was not enough room in the IPL table to display
all installed I2O block-storage devices.
Operating system not found Operating system cannot be located on either drive A: or
drive C:. Enter Setup and see if fixed disk and drive A:
are properly identified.
Parity Check 1 nnnn* Parity error found in the system bus. BIOS attempts to
locate the address and display it on the screen. If it
cannot locate the address, it displays
nnnn . Parity is a
method for checking errors in binary data. A parity error
indicates that some data has been corrupted.
Error Messages Corrective Action
D2U-NoSDJ.book Page 78 Friday, October 17, 2003 3:27 PM