AnyShop POS610, User Manual

Page: 35 / 80

-35-
This item allows you to setup the CPU thermal management function. Set the boot up Num Lock status. The options are “On” and “Off”.
Delay Prior to Thermal
With the default value of 16 Minutes, the BIOS activates the Thermal Monitor in automatic mode
16 minutes after the system starts booting up
The options: [4 Min], [8 Min], [16 Min], [32 Min].
Gate A20 Option
Normal : A pin in the keyboard controller controls GateA20
Fast : Lets chipset control GateA20 (Default)
Hard Disk Boot Priority
Set hard disk boot device priority.
Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the keyboard controller. The
commands are “Enabled” or “Disabled”. Enabling allows the typematic rate and delay to be
selected.
CPU L1 & L2 & L3 Cache
Enabling this feature speeds up memory access.
Security Option
This category determines whether the password is required when the system boots up or only
when entering setup. The options are:
- System : The system will not boot and access to Setup will be denied if the correct
Password is not entered at the prompt.
- Setup : The system will boot, but access to Setup will be denied if the correct
Password is not entered at the prompt.
Quick Power On Self Test
This allows the system to skip certain tests to speed up the boot-up procedure.
APIC Mode
This setting allows you to enable the APIC mode. The choices are “Disabled” or “Enabled.”
First / Second / Third Boot Device
The BIOS tries to load the OS from the devices in the sequence set here. The options are:
MPS Version Control for OS
This option is only valid for multiprocessor motherboards as it specifies the version of the
Multiprocessor Specification (MPS) that the motherboard will use. The MPS is a specification by
which PC manufacturers design and build Intel architecture systems with two or more processors.
MPS 1.1 was the original specification. MPS version 1.4 add extended configuration tables for
improved support of multiple PCI bus configurations and greater expandability in the future. In
addition, MPS 1.4 introduces support for a secondary PCI bus without requiring a PCI bridge.
Boot Other Device
Use this to boot another device. The options are “Enabled” and “Disabled”.
Delay for HDD (Secs)
The default is [0].
Small Logo (EPA) Show
This item allows you enabled/disabled the small EPA logo show on screen at the POST step.