Anthony Lifgtates, Inc.
22
AST, AST-L, and AST-PLUS Models
www.anthonyliftgates.com
800-482-0003
4.4.8 Adjust Latch Pin
1. Adjust the latch pin plate allowing a 1/16 to 1/8
inch gap between the latch plate and the latch pin.
Insufficient clearance can allow binding of the latch
pin as the liftgate is used, while too much clearance
will not properly secure the liftgate. If the latch pin
will not easily open, press the UP control button to
release any tension on the latch pin.
4.4.9 Installing DOT Lighting, Decals, and Any
Components Not Part of Liftgate
1. Install DOT lighting or other electrical components.
2. Install the license plate bracket.
3. If required, install grab bars or hand rails.
NOTICE
Most liftgates have built-in steps to
assist in ingress/egress of the
platform. These steps are NOT to
be considered all-inclusive of any requirements or
guidelines regarding proper ingress or egress. It is the
installer’s responsibility to determine the proper
requirements, such as steps, hand grips, grab bars, etc.
4. Attach all decals, as shown in section “5. Decals” on
page 27.
5. Make a final operation check. Refer to section
“4.4.10 Final Inspection Checklist” on page 23.
