CHAPTER 2 DECADE II DCC upgrade kit install guide, edition 5
17
5. Removing sensor board
To access the control board it is necessary to remove the sensor board
completely. This is done in the following manner:
•
Disconnect the internal cell cable depicted in figure 4(B) and 6 This is a
subD connector, which is fixed with two screws. Remove the screws with
the hex key and remove the connector of the sensor board.
•
Disconnect the I
2
C/power cable depicted in figure 4 (C). This is a Molex kk
connector, which can be removed by gentle pulling it in the upward
direction.
•
Remove the three M3 screws which secure the sensor board on the
connector panel using a Phillips screwdriver. The screws are marked in
figure 7 with red circles.
Figure 6 Removal of internal cell cable connector.
Summary of Contents for DECADE II
