CHAPTER 2 DECADE II DCC upgrade kit install guide, edition 5
13
2. Removing the rear panel
Both circuit boards are mounted on a separate metal frame, which are fixed on
the rear panel of the detector. The circuit boards can be accessed by removal
of the rear panel by means of the four M3 Phillips screws as depicted in figure
2. The screws are marked with red arrows and the letters A and B.
Figure 2 Connector panel of the DECADE II
.
1. Remove the two screws located below (A) completely by means of a
Phillips screwdriver. The screws in the top part (B) can be accessed
via the two holes in the connector panel, see top-right picture in
figure.
Do not remove the two screws in the top part completely. Just loosen
the screws five turns to remove rear panel.
Summary of Contents for DECADE II
