ArcSource 96 Integral (RGBW)
16
DM.In.
---
DMX values
. Select this function to read DMX values of each channel received by the fixture.
tEMP
---
Fixture Temperatures.
Select this menu to read the temperatures of the fixture:
Cur.t.
--- the current temperature of the fixture inside.
Hi.tE.
- the menu item shows the max. temperatures of the fixture inside since
the ArcSource 96 Integralhas been fabricated.
rSEt
--- the menu item shows the maximum temperatures of the fixture inside since the counter
was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN
buttons and at the same time press the ENTER button.
Measuring points:
LEdS
.--- the temperature of the LEDs module.
boAr.
--- the temperature on the PCB in the fixture base.
Note: The ambient temperature should not exceed 40°C.
The temperatures can be displayed in either °C or °F units - see option “tEM.U“ in the menu “Pers“.
VErS.
---
Software Versions.
Select this function to read the software version of the fixture processor.
6.3 Personality
Use this menu to modify the ArcSource 96 Integraloperating behaviour.
DM.Pr.
---
DMX preset
. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
DiSP.
---
Display adjusting
. This function allows you to change the display settings.
d.On
--- this function allows you to keep the display on or to turn off automatically 2 minutes
after last pressing any button on the control panel.
d.Int.
--- select this function to adjust the display intensity (30-min.,100-max.).
turn
--- select this function to turn the display by 180°.
tEM.U.
---
Temperature Unit.
Use this menu in order to display the fixture temperatures in desired units: °C or °F.
bALA --- Balance
Use this menu item to enable (On) or disable (Off) the white balance which is set in the “White
colour balance“ menu below. I f this function is set off, the ArcSource 96 Integral will use maximum values (255) of
saturation for red, green and blue colour. This function has to be set on before adjusting a white balance.
C.bAL.
---
White Colour Balance.
The menu gives access to the setting of the white balance.
To set white colour balance.
1.
Use a DMX controller or the “ Man.C.“ menu to set all LEDs on max. saturation.
2.
Use the UP/DOWN buttons to find the “ Pers.“ menu.
3.
Press the ENTER button.
4.
Use the UP/DOWN buttons to select the “C.bAL“menu.
5.
Press the ENTER button and the “rEd“ item will appear on the display.
6.
Press the ENTER button and use the UP/DOWN buttons to set new max. value for the red LEDs.
7.
Press the ENTER button to confirm the choice.
8.
Use the UP/DOWN buttons to select next colour, the “GrEn“.
9.
Repeat steps 6-7 for this channel.
10.
Use the UP/DOWN buttons to select the last colour, the „bLuE“ and repeat steps 6-7 for this colour.
Summary of Contents for ArcSource 96 Integral
Page 1: ...Version 1 6...
Page 28: ...ArcSource 96 Integral RGBW 28...
