ArcPad Xtreme (Single colour)
8
2. RDM Communicator
Note: DMX controller has to be disconnected from the fixture when the RDM communicator is operated.
After addressing and setting fixtures´behaviour you can use the Cyber Arch (after programming it) for stand-alone
operation of fixtures.
3.5 DMX 512 connection
To build a DMX chain
1.
Connect the DMX output of the controller directly with the DMX input of the first fixture in the DMX chain.
2.
Connect the DMX output of the first fixture in the DMX chain with the DMX input of the next fixture.
3.
Always connect the DMX output with the input of the next fixture until all fixtures are connected.
Do not overload the link. Max. 32 fixtures may be connected on a DMX link.
Caution: Terminate the output of the last fixture with a 120 Ohm resistor wired betwen data (+) and data (-) in
order to ensure the proper transmission on the data link.
3.6 Master/slave connection
To build a master/slave-chain:
Connect the DMX output of the master fixture in the data chain with the DMX input of the first slave. Always
connect output with the input of the next slave until all slaves are connected (up to 32 fixtures).
Caution: It is necessary to terminate the input of the master fixture and the output of the last slave with a 120 Ohm
resistor in order to ensure the proper transmission on the data link.
Summary of Contents for ArcPad Xtreme
Page 1: ...Version 1 7...
Page 29: ...ArcPad Xtreme Single colour 29...
