ArcPad Xtreme (Single colour)
18
Programming (e.g. if you want to create program with 10 steps, set P.End=10).
“
COL.1” -
LEDs saturation-array1 (0-255)
“COL.2“ - LEDs saturation-array2 (0-255)
“Stro.“ - a strobe, shutter (0-255)
“dimr“ - a dimmer (0-255)
“F.dim“ - a fine dimmer (0-255)
“F.tim.“ - a fade time, (0-25.5) seconds
“S.tim.“ - step time, value (0-25.5) seconds
“COPY“. – this item duplicates the current prog. step to the next prog. step. The item “P.End” is increased
automatically.
6.
Use the UP/DOWN buttons to set a DMX value of the channel and then press the ENTER button.
7.
Use the UP/DOWN buttons to select next channel and press the ENTER button.
8.
After having set all channels in the current program step, press the MODE button to go by one menu level
back and select another program step.
6.7 Special functions
rdML
---
Code
.This menu item shows the first part of the RDM identification code.
rdMH
---
Code
. This menu item shows the second part of the RDM identification code.
AdJ
---
Effect Adjustment.
The menu allows calibration of each LEDs array.
dMH
---
DMX Values.
The menu item enables to control all LEDs before calibrating each LEDs array.
CAL.U
---
Calibrating unit.
The menu serves for fine current calibration of LEDs during fixture burn-in at
a factory. Each LED array can be calibrated separately. Users should not change the setting.
Hold
---
Hold DMX
. If the function is on, the last received DMX values are held in case, that DMX data receiving
was interrupted (e.g. disconnected DMX controller).
uPd.M.
---
Updating mode
. The menu item allows you to update software in the fixture via either serial or USB port
of PC.
The following are required in order to update software:
- PC running Windows 95/98/2000/XP or Linux
- DMX Software Uploader
- Flash cable RS232/DMX No.13050624 (if you want to use a serial port of PC)
- Robe Universal Interface (if you want to use an USB port of PC)
Note1: Software update should execute a qualified person. If you lack qualification, do not attempt the update
yourself and ask for help your ROBE distributor.
Note 2: DMX address, programs 1-3 and all items in the menu "PErS" will be set to their default values.
To update software in the fixture:
I
. Installation of the DMX Software Uploader.
1.
DMX Software Uploader program is available from theAnolis web site at WWW.anolis.cz.
2
. Make a new directory ( e.g. Anolis_Uploader) on your hard disk and download the software into it.
3
. Unpack the program from the archive.
II.
Fixture software updating.
If you use the RDM Communicator:
1.
Disconnect the fixture from other fixtures in a DMX link.
2.
Connect the RDM communicator to the fixture and switch this fixture to the update mode :
1
Use the UP/DOWN buttons to find “
SPEC.
“ menu.
Summary of Contents for ArcPad Xtreme
Page 1: ...Version 1 7...
Page 29: ...ArcPad Xtreme Single colour 29...
