Anolis ArcPad Xtreme, User Manual

Page: 16 / 29

ArcPad Xtreme (Single colour)
16
Note: The ambient temperature should not exceed 40°C.
Measuring points:
LEdS .--- the temperature of the LEDs module.
boAr. --- the temperature on the PCB in the fixture head.
The temperatures can be displayed in either °C or °F units - see option “tEM.U“ in the menu “Pers“.
VErS. --- Software Versions. Select this function to read the software versions of the fixture processors.
IC1 --- the processor controls LEDs module
IC2 --- EEprom
6.3 Personality
Use this menu to modify the ArcPad Xtreme operating behaviour.
DM.Pr.
---
DMX preset
. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX
protocol" for detail description of each DMX mode.
DiSP.
---
Display adjusting
. This function allows you to change the display settings.
d.On --- this function allows you to keep the display on or to turn off automatically 2 minutes
after last pressing any button on the control panel.
d.Int. --- select this function to adjust the display intensity (20-min.,100-max.).
turn --- select this function to turn the display by 180°.
tEM.U. --- Temperature Unit. Use this menu in order to display the fixture temperatures in desired units: °C or °F.
LoAd --- Load of LEDs . The menu allows to choose 2 operating modes for fixture.
FuLL --- Maximum light output.
EcO. --- The light output is decreased by 25%.
In.Po.
--- Init effect positions. Use this function to set all effects to the desired positions to which they will move
after switching the fixture on (if DMX is not being received).
Note. If DMX mode 1 is selected, only values set at items “MACr” (macro) and dinr (dimmer) will be accepted.
dF.SE.
---
Default Settings .
The menu item sets all fixture parameters to the default (factory) values.
6.4 Manual mode
Use this menu for control the fixture without connected DMX console.
PrE.C. --- Preset effects control. Select this menu to call up preset positions of the channel effects.
Man.C. --- Manual effect control. Select this menu to control all channels via buttons of the control board.
To control fixture channels.
1. Use the UP/DOWN buttons to find “ Man.C“ menu.
2. Press the ENTER button.
3. Use the UP/DOWN buttons to select desired effect (channel).
List of control channels:
“
COL.1” - LEDs saturation-module 1
“COL.2“ - LEDs saturation-module 2
“Stro.“ - a strobe, shutter