AWG08-001 Audio Warning Generator
Installation and Operation Manual
January 21, 2019 Rev: 1.01
Page 2-1
ENG-FORM: 805-0102.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Section 2.0 Installation
2.1
Introduction
Information in this section consists of: unpacking and inspection procedures, installation procedures, post-
installation checks, and installation drawings.
2.2
Unpacking and Inspection
Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each unit should have the following:
- AWG08-001
- Acceptance Test Report
- Certificate of Conformity or Release certification
- USB Cable
Verify that all items are present before proceeding and report any shortage immediately to your supplier.
2.2.1
Warranty
All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 3 years. See the website
www.aem-corp.com/warranty for complete details.
2.3
Installation Procedures
2.3.1
Warnings
WARNING:
High volume settings can cause hearing damage. Proper personal
protective equipment is required to prevent hearing damage.
2.3.2
Cautions
CAUTION:
The AWG08 inputs and outputs are adjusted from factory to achieve 100mW
rated output into a 600 Ohm load for Audio Output 1 and 2.
The AWG08 audio outputs are not intended to drive load impedances less than
600 Ohms. Audio output or warning level adjustments to achieve clear and
comfortable sound pressure levels may be required.
Warning audio output levels are dependent on the signal level set in the loaded
warning file. All warning file signal levels should be verified to be similar.
