Anita Garudan GZ-539 Series, User Manual, Page: 147 / 155

137
Number Name of Malfunction Sub-information Content
E-038 Motor is blocked 2
Please turn off power
。
E-039 Motor over speed Please turn off power
。
E-040 Over current in stop status
Please turn off power
。
E-041 Motor overload Please turn off power
。
E-042 Bus voltage abnormal
Please turn off power
。
E-044 Head board EEPROM I/O Error Please turn off power
。
E-045 Component abnormal
Please turn off power
。
E-046 CRC check error
Please turn off power
。
E-047 Data check error Please turn off power
。
E-048 X check error
Please turn off power
。
E-049 Y check error Please turn off power
。
E-050 MD1 stepping over-current
Please turn off power
。
E-051 MD1 X direction not finish Please turn off power
。
E-052 MD1 Y direction not finish
Please turn off power
。
5.2 Hint Information List
Number Name of Malfunction Sub-information Content
M-001 Trim counter reaches set value Press Enter
M-002 Bottom thread counter reaches MAX value Press Enter
M-003 Set value is too large Please input value within valid range
M-004 Set value is too small Please input value within valid range
M-005 Save parameter abnormal Press Enter to restore the default values
M-006 Memory full Please delete the idle sewing data
M-007 Delete pattern data from memory?
Press ENTER to perform the deletion; Press ESC to
quit the operation
M-008 Replace pattern data in memory?
Press ENTER to perform the replacement; Press ESC
to quit the operation
www.garudan.cz