Anilam 4200T, Manual

Page: 8 / 48

CNC Motion Setup/Testing Utility
P/N 70000634C
Clearing a Prompt Field or Message (F1)
Press ClrFld ( F1 ) to clear an erroneous entry. This soft key is available
during the Signal Gain and Tuning tests.
Selecting an Axis
NOTE: Select an active axis before you select an MST command
( F1 – F10 ). If you do not select an axis, the CNC displays an
Error message that prompts you to select an axis.
Use the following keypad keys to select and activate the corresponding
axes:
X
Activates/Deactivates X-axis
Z
Activates/Deactivates Z-axis
S
or
S
Activates/Deactivates Spindle Axis
X
Z
S C
The CNC displays the active axis in the upper-left corner of the General
Status area of the MST Screen.
Entering a Password
When you enter the MST Utility and press Balance ( F6 ), SigGain ( F7 ), or
Tuning ( F8 ), the CNC prompts for the password. Type the appropriate
password and press
ENTER
. Refer to 4200T CNC Setup Utility Manual ,
P/N 70000414, “Section 1, Password Restricted Parameters.”
The soft key activates. If you have entered the password successfully,
the CNC will not prompt for the password again, unless you exit and
re-enter the MST Utility.
All rights reserved. Subject to change without notice.
November 2009
4